參考看看。
http://www.corner-stone.com.tw/u ... elling_Tutorial.pdf
FloTHERM Transient Modeling Update Tutorial for V10
By: Akbar Sahrapour, Mechanical Analysis Division
Last Modified: January 29, 2014
Based on a previous work by Kelly Cordell-Morris
Introduction
The transient setup method has changed in FloTHERM10. The transient setup has been streamlined to help you set up a time-dependent model more easily by using only a single dialogue. This tutorial has been created to show the steps required to set up such a transient model and then how results might be viewed in the Visual Editor.
The tutorial assumes that you fairly familiar with FloTHERM and its menus and know how to create simple geometry and apply attributes. The model consists of only two cuboids of different materials and with a periodic heat load to one of them. The model is not intended to represent any real world application but merely to explain the improved functionality of the software.
Function and limitation
Transient profiles can be applied to source attributes, thermal attributes and ambient attributes for temperature and radiant temperature.
Solar radiation cannot have a transient profile applied and remains a steady state calculation. Please contact your local support for advice on how to model a transient solar radiation application.
Tutorial Example
Start FloTHERM. If FloTHERM has already been started, select [Project/New]. Load the Default SI project.
|
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
抢沙发
千斤顶
显身卡